Displays In The Case Of A Hardware Error - Fujitsu S120 Series Operating Manual

Problems with the S120

8.1.1 Displays in the case of a hardware error

The S120 informs you of hardware errors in the following manner:
On the S120 control panel


If the yellow CHECK light illuminates, there may be a hardware error.
At the same time, the Flag code appears on the LCD display. This can indicate an error
in the service processor or a machine error.
On the screen of the SKP console in the SVPST0 window


On the SKP console, displays in line 24 in the SVPST0 window of the SVP frame can
indicate a hardware error. Evaluation of the Flag code is carried out by the service
department. The following diagram shows the format of the error display:
cccc
RA
Figure 56: Flag code display in line 24 of the SVPST0 screen
The Flag code
measures:
–
–
–
–
92
..............................
. . .
FF FF
A WRITE-CONSOL message is displayed. It can be deleted with the
does not delete the Flag code display.
A warning is issued, e.g. if the room temperature is too high. The cause of the error
must be eradicated. System operation can continue in the meantime.
An error has occurred in the S120 or on the interface to the peripheral devices which
was automatically corrected by the hardware. In this case, system operation can
also be continued.
An error has occurred which does not permit system operation to be continued. In
this case, you can take the following measures:
If the system is down, execute an IMPL. If this does not solve the problem, contact
the service department and discuss what steps should be taken.
..
M
can have different meanings and can therefore require different
cccc FLAG CODE = FFFFFFFF FFFFFFFF
[]-[]00
Troubleshooting
key. This
F3
U41182-J-Z126-1-74