American Standard Paradigm Selectronic 7025.1 Series Installation Instructions Manual page 3

Paradigm
Roughing-in Dimensions
FINISHED WALL
OR BACKSPLASH
CLEARANCE
25 mm (min)
(1" min)
597 mm
(23-1/2")
RECOMMENDED TOOLS
1. 2.5 mm Hex Wrench (Included)
2. Adjustable Wrench
3. Plumbers' Putty or Caulking
4. Flat Blade Screwdriver
5. Tape Measure
SPOUT ASSEMBLY INSTALLATION;
1
Fig. 1
Turn off hot and cold water
CAUTION
supplies before beginning
1. Make sure O-RING (1) is installed in spout base.
IMPORTANT: Do not use putty when installing faucet
without escutcheon.
2. If installing DECK PLATE (2) (optional): Apply a bead
of putty to bottom edge of PUTTY PLATE (2). Install
SCREW (11) into the MOUNTING BASE OF THE
FAUCET (13) and allign SCREW (11) with HOLE (12).
3. Insert SUPPLY HOSES (3), SHANK (4) and SENSOR
CABLE (5) (only included in base model) through hole
in DECK PLATE with PUTTY PLATE (2) and mounting
surface.
4. Assemble RUBBER WASHER (7), BRASS WASHER (8)
and THREADED LOCKNUT (9) onto SHANK (4) from
underside of sink or mounting surface. Hand tighten
LOCKNUT (9).
5. Use a screwdriver to tighten SCREWS (10) on
LOCKNUT (9). Work your way around LOCKNUT (9),
tightening the screws slightly each time until all are
snug to ensure even pressure.
189 mm
(7-1/2")
192 mm
(7-1/2")
169 mm
(6-5/8")
140 mm
(5-1/2")
38 mm
(1-1/2")
3/8" COMPRESSION
CONNECTORS
Note: All plumbing and electrical wiring must be installed in
accordance with applicable codes, regulations and standards.
CAUTION: Use only American Standard
supplied transformers and cable sets.
Using non-AS supplied cables, or cutting,
splicing or modifying any components
39 mm
(1-1/2")
will void the warranty.
59 mm
51 mm
(2-3/8")
(2")
28 mm
(Ø1-1/8")
RECOMENDED CONTROL BOX OR
EQUIVALENT BY OTHERS
4" (102mm) SQ. X 2-1/2" (64mm) DEEP 2-GANG ELECTRICAL
BOX Appleton #4SD1 OR EQUAL (BY OTHERS).
(Used with Hard-Wired AC Transformer)
Fig. 2
3
Fig. 1
13
11
12
5
3
7
8
9
3
1
2
4
5
I
MPORTANT: Do not
use putty when installing
faucet without escutcheon.
1
4
2
(OPTIONAL)
PUTTY
(If required)
MOUNTING
SURFACE
TIGHTEN
SPIN NUTS
I
MPORTANT: Do not
use sealent on threads
10
M965985 (11/18)
10'