Timer And Buzzer Check - Southbend SEZ/3 Operator's Manual

SEZ S C
ERIES OUNTERTOP
Figure 12

Timer and Buzzer Check

1. DISCONNECT POWER AT CIRCUIT BREAKER.
2. Remove control panel.
3. Set timer for one minute and allow to time out. If timer does not run, then replace.
4. Remove buzzer lead wires from timer and terminal block position 2.
5. Place test leads between positions 1 and 3 on the timer.
6. Check for continuity. If no continuity, replace timer.
7. Place test leads in terminals of buzzer lead wires.
8. Check that resistance is approximately 3.4 Kohms. Otherwise, replace buzzer.
O
S
TEAMERS
' M 1183437
PERATOR S ANUAL
T
ROUBLESHOOTING
Buzzer
Timer
P 29
AGE