Download Print this page

Toslon X-Pilot Quick Start Manual page 8

Autopilot for bait boats

Advertisement

3.3
Menu List
Waypoints
X-Pilot Setting
System Setting
Advanced Set.
System Info.
List of stored waypoints
Wiring Test
Test if the X-Pilot could control the boat properly
Set different RF channel to allow more than one users
RF Channel
operating the device in the same region without any
radio interference
Steering sens.
Set the sensitivity of boat steering
Compass Cali
Used for calibration of compass
Compass Test
Used to check if compass working normal or not
Beeper
Set if the unit sound a tone or not when a key is pressed
Backlight
Allow the unit to be used at night
Contrast
To get a suitable display when operate the unit
Sounds when the input battery voltage of transmitter is
Boat Voltage
equal to or less than the setting
Set if the display sounds with warning message when
Dsp. Voltage
the input battery voltage of display is low enough
Time Zone
Selects time zone for using in different countries
Language
Select the display language for menus
Load Default
Used to restore original factory setting
Boat Option
Select boat type to match X-Pilot setting
CH Reverse
To correct the running direction of motor (or rudder)
Channel Limit
Limite the max speed of boat (with X-Pilot built in)
Dev. Mode
Developing Mode for engineer test
Show system information of device

Advertisement

loading
Need help?

Need help?

Do you have a question about the X-Pilot and is the answer not in the manual?

Subscribe to Our Youtube Channel

Related Products for Toslon X-Pilot