Advertisement
2.3
Save a waypoint
How to save a waypoint?
X-Pilot could save up to 500 waypionts in the memory.
1) Push the [Up] key to enter into the waypoint
interface.
2) Move the [Up] or [Down] key to select an
slot to save to.
3) Push [Enter] key. An message-box appears
remind if you will save the waypoint.
4) Select [Yes] to comfirm.
Waypoint 1/100
H
0427-161201
2
0615-161004
3
0930-160842
4
XXXX-XXXXXX
5
XXXX-XXXXXX
Lat.: xxx xxxx
Lon.: xx xxxx
Blank position
Messages
Save to Slot?
Yes
No
Advertisement
Need help?
Do you have a question about the X-Pilot and is the answer not in the manual?
Questions and answers
How do i calibrate Tolson x pilot
To calibrate the Toslon X-Pilot, follow these steps:
1. Perform Compass Calibration:
- Calibration is required when installing the X-Pilot on a new boat or moving to a new environment.
- Do not calibrate the compass inside a house or car.
2. Compass Test:
- Use this function to check if the compass is working correctly.
3. Adjust Sensitivity:
- If the boat is light and flexible, set a lower sensitivity.
- If the boat is heavier, set a higher sensitivity.
These steps ensure accurate navigation and stability of the X-Pilot system.
This answer is automatically generated
What happens when u go to calibrate compass through settings as i just get a picture of a boat with a left and right arrow and then it just goes off no status bar showing calibration or anything to say its completed and compass is still of a bit Im pulling my hair out with it even moved compass outside of boat (orange compass)
If the Toslon X-Pilot compass calibration process shows a boat image with arrows but does not complete the calibration, perform the [Wiring Test] to check if the motor or rudder is controlled properly. If the motor or rudder does not move correctly, go to the [Advanced Set.] / [CH Reverse] menu and reverse the relevant channel.
This answer is automatically generated