Chapter 8: Factory Page - Watlow EZ-ZONE PM User Manual

8

Chapter 8: Factory Page

Navigating the Factory Page
To navigate to the Factory Page follow the steps below:
1. From the Home Page, press and hold both the Advance
onds.
2. Press the Up ¿ or Down ¯ key to view available menus.
3. Press the Advance Key
4. If a submenu exists (more than one instance), press the Up ¿ or Down ¯ key to select and
then press the Advance Key
5. Press the Up ¿ or Down ¯ key to move through available menu prompts.
6. Press the Infinity Key ˆ to move backwards through the levels: parameter to submenu, sub-
menu to menu, menu to Home Page.
7. Press and hold the Infinity Key ˆ for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's op-
tions. See model number information in the Appendix for more information. If there is
only one instance of a menu, no submenus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon
controller part number.
CUSt
FCty Custom Setup Menu
1
Custom Setup (1 to 20)
CUSt
Parameter
par
Instance ID
iid
LoC
FCty Security Setting Menu
Operations Page
LoC. o
Profiling Page
LoC. P
Password Enabled
pas. E
Read Lock
rLoC
Write Security
SLoC
Locked Access Level
LoC. L
Rolling Password
roLL
User Password
pas. u
Wa t lo w E Z -ZO N E ®
to enter the menu of choice.
‰
to enter.
‰
P M I C o nt ro l l er
and Infinity ˆ keys for six sec-
‰
Administrator Password
pas. a
ULoC
FCty Security Setting Menu
Public Key
CodE
Password
pass
diAg
FCty Diagnostics Menu
Part Number
Pn
Software Revision
rEu
Software Build Number
S. b Ld
Serial Number
Sn
Date of Manufacture
dAtE
IP Actual Address Mode
ip. a C
IP Actual Address Part 1
ip. a 1
IP Actual Address Part 2
ip. a 2
• 168 • Cha pte r 8 F a ct or y Pa g e