Watlow EZ-ZONE PM User Manual page 51

EtherNet/IP™, PCCC and Modbus
Slot B, E
unused
E8
unused
E7
receive -
E6
unused
E5
unused
E4
receive +
E3
transmit -
E2
transmit +
E1
• Do not route network wires with power wires.
• Connect one Ethernet cable per controller to a 10/100 Mbps Ethernet
• Communications instance 2
Slot B
PM [6] _ _ _ _ - [3] _ _ _ _ _ _
Slot E
PM[4,8,9] _ _ _ _ - [3] _ _ _ _ _ _
Note:
When changing the fixed IP address cycle module power for new address to take effect.
Ethernet LED Indicators
Viewing the control from the front and then looking on top four LEDs can be seen aligned
vertically front to back. The LEDs are identified accordingly: closest to the front reflects the
Network (Net) Status, Module (Mod) Status is next, Activ-
ity status follows and lastly, the LED closest to the rear of
the control reflects the Link status.
Note:
When using Modbus TCP, the Network Status and Mod-
ule Status LEDs are not used.
Wa t lo w E Z -ZO N E ® P M I C on t rol l er
® TCP Communications
RJ-45 pin T568B wire color
8 brown
7 brown & white
6 green
5 white & blue
4 blue
3 white & green
2 orange
1 white & orange
switch. Both Modbus TCP and EtherNet/IP™ are available on the net-
work.
Signal Slot B, E
unused E8
unused E7
receive - E6
unused E5
unused E4
receive + E3
transmit - E2
transmit + E1
• 47 •
Network Status
Module Status
Activity Status
Link Status
C ha pt er 2 Ins ta ll an d W ir e