Siemens SIMATIC Operating Manual page 7

Software requirements
● One of the operating systems listed in the section "Supported operating systems" was
installed.
● The driver of the device manufacturer for the graphics adapter is installed.
● Installed SIMATIC software must be uninstalled.
– IPC Ethernet Monitor V1.x
– IPC PDT V1.x
– IPC Wizard V1.x to 2.x.x
Hardware requirements
For the PDT software, you need a PC with the following properties:
● DVD drive or external USB data carrier
● Display port or DVI interface
● 1 GHz processor or higher, 32-bit (x86) or 64-bit (x64)
● 2 GB RAM
● 3 GB free hard disk memory
● Use graphics driver matching the graphics interface in use
● Screen resolution at least 800 × 600 pixels
Note
Initial commissioning
The IFP must be connected to the PC during initial commissioning.
Number of IFPs on a PC
The number of IFPs which can be connected to a PC depends on the system configuration
and operating mode. You can find the possible combinations in the FAQ 109483774 on the
Internet (https://support.industry.siemens.com/cs/us/en/view/109483774).
Mixed operation not allowed
The simultaneous operation of the following device combinations in connection with a PC is
not allowed:
• Device with display diagonal 4:3 and devices with display diagonal 16:9
PDT IFP Monitor Standard
Operating Manual, 10/2017, A5E41104536-AB
Panel Drivers and Tools software
1.2 System requirements
7