Software Description; General Information; Brightness - Setbrightness; Overview Ipc/Ifp - Siemens SIMATIC Operating Manual

Software description

3.1

General information

Note
Full device detection
If you connect or remove an IFP while the Configuration Center is open, this change is not
immediately detected by the Configuration Center. Only when an IFP has been fully detected
can you make settings for this IFP in the Configuration Center. For full detection or update of
the devices in the Configuration Center, select "Menu > Refresh" or restart the Configuration
Center.
3.2

Brightness - SetBrightness

3.2.1

Overview IPC/IFP

Adjusts the display brightness for all connected and detected devices. If the PC used is a
third-party PC, setting the display brightness of the PC is not supported.
3.2.2

Setting the display brightness

Procedure
Note
Deviating numbering
Depending on the graphics chip and operating system, the sequential numbering of the
devices may deviate from the numbering in Windows:
16
PDT IFP Monitor Standard
Operating Manual, 10/2017, A5E41104536-AB
3