The data backup consists of the following components:
● NC/PLC/DRV archive
● Creation of CF card backup
5.2.8
Complete package processing
Acknowledge the message to complete the tool processing.
Figure 5-11
Switch the machine off and remove the USB flash drive.
After a POWERON, the machine is completely ready for operation.
5.2.9
LOG file
After processing of the SINUMERIK Software Update Tool, a LOG file is generated and saved
on the USB stick.
The LOG file is an *.htm file, which you can open in a browser. It contains the executed
sequence of the tool.
SINUMERIK Software Update Tool
Commissioning Manual, 03/2018, A5E42187770B AA
Upgrading software with the SINUMERIK software update tool
5.2 Executing the SINUMERIK Software Update Tool Vx.y.usz
SINUMERIK software update tool - processing completed
33