Assembling A Gas-Cooled Tig Torch; Design With Central Burner Connection Gwz; Design With Fronius Central Welding Torch Connection F - Fronius TransTig 1600 Operating Instructions And Spare Parts List

Assembling a gas-cooled TIG torch

Design with -
central burner -
connection GWZ
-
-
Important! Please see your torch's instruction manual for technical details on the torch
and for information on torch assembly, care and maintenance.
Gas and current
connection
Fig. 6
Design with
-
Fronius central
welding torch
-
connection F
Important! Please see your torch's instruction manual for technical details on the torch
and for information on torch assembly, care and maintenance.
Gas and current
connection
Fig. 7
Pull back the rubber sleeve from the rear of the torch
Screw the hexagon nut (width across = 21) of the gas+current connection onto the
torch connector point on the machine [A]
and tighten firmly
Push the rubber sleeve back over the hexagon nut
Plug the control plug into socket [C] and latch it
Design with central burner connection GWZ: Torch connection gas-cooled
Insert welding torch bayonet connection in the central connection on the equipment
side of the welding torch [A] and lock in place by turning to the right
Insert control plug in the socket [D] and lock in place
Design with Fronius central welding torch connection F: Torch connection gas-cooled
Control plug
Control lead
Hose sleeve
Control plug
Control lead
Hose sleeve
7