Table of Contents
Advertisement
Install the Showerhead
Elbow
Supply Pipe
Apply thread sealant tape
1.
Apply PTFE tape over the threaded end of the shower arm. Do not use
paste.
2
Turn on the water and allow water to flow through the shower arm to flush out
any dirt and debris.
3.
Turn off the water.
4.
Tighten the showerhead onto the shower arm until hand tight.
5.
Use a suitable spanner to tighten the showerhead onto the shower arm. Do
not overtighten.
Complete the Installation
1.
Turn on the shower valve (not shown).
2.
Check for leaks. Make adjustments as required.
3.
Rotate the handshower face to verify smooth operation of the spray options.
4.
Turn off the shower valve.
Shower Arm
Apply thread sealant tape
3
Make sure that the
'KOHLER' logo is
at the top
1151983-W2-A
Advertisement
Table of Contents
