Loading Paper - Royal 140DX Instruction Manual

8) LOADING PAPER

___________________________________________________________
HOW TO LOAD THE PAPER
This register uses standard 2 ¼ inch (57mm) single-ply bond paper to produce a customer receipt.
Fig. E
NOTE: It is recommended to use ROYAL brand 2 1/4" (57mm) bond paper, which will help prevent dust
deposits on the printer mechanism caused by inexpensive paper rolls. Replace with standard bond quality
calculator paper. ROYAL Part #013129.
To order, call the Royal Supply Center toll free at 1-888-261-4555.
1. Plug in your cash register.
2. Grasp the printer cover by the finger tab on front, left side of the cover. Gently pull up on the front of the
cover and then raise it towards the back of the cash register (it is on a hinge and can be completely
removed from the register). (Figure E)
3. Cut or tear the end of the paper roll evenly for a straight edge to permit proper feeding through the print
head.
4. Place the paper roll in the paper holder so that the paper will feed out from the bottom of the roll toward
the front of the register.
5. Insert the end of the paper roll into the paper slot (Figure F), the printer under the black plastic writing
table.
6. Depress the [ ] key until the paper catches and advances through the printer.
7. If the paper does not feed through the printer, make sure the paper has a smooth, straight edge and was
inserted in the proper slot.
8. Pass the tape through the receipt window of the printer cover, in front of the metal paper cutting blade, if
a customer receipt is desired.
9. Close the printer cover.
Fig. F
8