CONCORD 2800 Operator's Manual page 73

3. Operation
4. Review the Catch Test Results:
a. The results may vary based on initial values.
5. It is suggested that you recalibrate after you
received the results. This allows for the machine
to make the adjustments and obtain a more
accurate calibration number.
6. Press OK
3.11.3 Taking a product sample for calibration from Field Computer (In Cab)
If the auxiliary display is not available the calibration process can be completed from the In-Cab Field Computer
1. Select the Settings and select System Settings
2. Rate Sensor Set up (1).
3. Enter a Calibration Value based on door opening.
4. If the product density is known, enter it for the
desired product.
Do not Change the Product Density After
Calibrating - The calibration number will
change
5. Select Catch Test Calibration.
6. Select Check Mark (1).
Fig. 32
72