CONCORD 2800 Operator's Manual page 111

3. Operation
15. Product Density and Calibration weight can be
entered here, however, if these values are not known,
they can be entered in the Rate Sensor Setup Page.
The hydraulic meter motor has 60 pulses/revolution:
16. The tank capacity in lbs may vary based on product
density, configure the bin levels for Product 1 as
shown. Tank Levels can be entered in the Tank Fill
Settings page.
17. The preset values do not affect machine performance
on a Hydraulic Drive, Enter Values you wish.
These are also editable after Profile set up is
complete
110