CONCORD 2800 Operator's Manual page 70

3. Operation
Setting Machine Width:
Select Settings and select the Applicator Set up tab.
Verify that your machine width (1) is populated correctly.
If the width is correct move onto the calibration
procedure, if not follow the next steps:
1. Select Edit
a. The ECU will prompt you asking if want to
Remove/Edit (1) a profile from the list, Select
the Check Mark
2. Select Profile name;
a. Typically this is the Model and Drive type of
the Air cart: ie: 3350HYD
3. Change the Application Width (1) of the machine.
4. Page Through the next screens until you reach the
Set up Summary;
a. Verify all settings are correct and select
next.
Fig. 24
Fig. 25
Fig. 27
69