Table of Contents
Advertisement
(c) At the cam assembly:
1
2
3
4
7H19
PIPER AIRCRAFT, INC.
PA-46-500TP, MALIBU MERIDIAN
MAINTENANCE MANUAL
In the cockpit, set the power lever at IDLE.
a
Adjust cam assembly as shown in Figure 3, Detail C.
b
Adjust the FCU control rod to obtain .25 to .3125 inch Forward Ng Pickup Dead
Band from the power lever idle stop in the cockpit pedestal.
NOTE: Shortening rod decreases Ng pickup dead band.
In the cockpit, set the power lever at FULL POWER.
Adjust cam assembly as shown in Figure 3, Detail D.
In the cockpit, set the power lever at BETA.
Adjust cam assembly as shown in Figure 3, Detail E.
In the cockpit, set the power lever at REVERSE.
a
Adjust cam assembly as shown in Figure 3, Detail F.
b
Adjust dead band adjustment screw on beta cam box to set Reverse Ng Pickup
Dead Band so that Ng pickup in reverse is delayed until RPM drops slightly. The
gap should be approximately .312 inch.
Power Lever Cable Adjustment
Figure 3 (Sheet 1 of 3)
76-10-00
Apr 15/07
PAGE 9
Advertisement
Table of Contents
Troubleshooting
