Piper Malibu Meridian PA-46-500TP Airplane Maintenance Manual page 1289

100876 F
100877 J
100879 H
FWD
A
B
B
A
VIEW OUT
WASHER(S)
(TWO MAX.)
NOTE 2
.06/.12 INCH FILLET SEAL WITH PR-1422
SECTION
6J13
PIPER AIRCRAFT, INC.
PA-46-500TP, MALIBU MERIDIAN
MAINTENANCE MANUAL
STORM WINDOW ASSY.
- BOND HINGE TO WINDOW PRIOR
TO BONDING LATCH PIN ASSY.
- MAINTAIN .030 INCH MINIMUM GAP
BETWEEN STORM WINDOW RETAINER
AND PILOT'S SIDE WINDOW.
- CENTER HINGE HALF IN CUTOUT AREA
AND ENSURE IT DOES NOT RIDE INTO
THE CORNER RADII.
INSTALL MS 20470AD3-3 RIVET
IN EACH END OF HINGE WITH
LOCTITE 420 TO RETAIN HINGE PIN
NOTE 1
(BEFORE BONDING, REMOVE KNOB FROM STORM WINDOW
ASSY. AND CENTER LATCH PIN TO THE .5 IN. DIAMETER HOLE
IN THE STEEL RETAINER. PIN MUST BE CENTERED WITHIN
.015 INCH. AFTER BONDING, WINDOW MUST OPERATE
SMOOTHLY WITHOUT DRAG OR BINDING.)
LATCH PIN
ASSY.
B-B
NOTES: 1. BOND WITH DEXTER HYSOL 9446.
2. BOND WITH PR-1422.
3. BOND SEAL TO RETAINER WITH RTV 157
4. EARLY SEALS AS SHOWN, LATER SEALS
AND SERVICE REPLACEMENT SEALS ARE
ARE RECTANGULAR CROSS-SECTION.
Storm Window
NOTE 3
NOTE 4
FILL GAP BETWEEN WINDOW
AND HINGE HALF WITH
DEXTER HYSOL 9446 ADHESIVE
NOTE 4
THIS SURFACE OF
HINGE HALF MUST
BE BONDED FLUSH
AGAINST WINDOW
APPLY PR1422-B4
SEALANT HERE
Figure 4
NOTE 2
NOTE 2
A-A
SECTION
56-10-00
Apr 15/07
NOTE 1
SILICONE
RUBBER
TUBE
PAGE 7