Inter-m NLM-8000C Manual

NLM 8000C
Local Machine
Features
This device is a wall controller that used by connect-
ing with MR-8000 mounted on NPX-8000. It can se-
lect the sound source and volume, and can expand
up to eight in the mode of Daisy Chain.
Front Panel
INPUT 1 INPU
INPUT 2 IN
I INPUT 3
3
1. Displaying Window
Sound source, volume, and status information of the
channel set at NPX-8000 are displayed.
2. Selecting Switch
It is a switch that can change the sound source and
volume, and select the status information.
It is selected if the switch is turned to control the
value you want and press the switch at the position
to select.
3. Led Status Displaying Led
It is LED that displays the operation status of the device.
- Channel mode: GREEN LED is on.
- Volume mode: BLUE LED is on.
- Sleep mode: When Led Control is ON, BLUE LED
is on. When Led Control is OFF, LED is off.
In case Led Control is OFF, LED turns off.
- Communication error: RED LED is on.
- Setup mode: MAGENTA LED is on.
- Others: RED LED is on at Mute status.
1
OUTPUT 1
N
2
Rear Panel
LM LINK
2
1. Termination Switch
It is a switch used in the device connected finally in
case of connecting the device using LM port of MR-
8000 by Daisy Chain mode.
2. Lm Link Port
It is the terminal that can connect power supply
(+40V) and communication, audio line.
<RJ45 Terminal Description>
NO
1
2
3
4
5
6
7
8
※ Be sure to use direct cable when connecting LINK
of device.
※ For cables, it is recommend to use those below
DCR 100m/9.8Ω.
1
LM LINK
Description
CAN – H
CAN - L
N.C
DC 40V
GND
N.C
Audio Out+
Audio Out-