Advertisement
NLM 8000C
Local Machine
Device setup method and cautions
1. Device Basic Operation
- Waiting Screen
1) If you connect NPX-8000 and NLM-8000C, power
is supplied to NLM-8000C, and NLM-8000C is
ON.
2) In case ID of NLM-8000C collides, ID set window
is displayed. In this case, ID is reset.
※ Refer to 2. Device set explanation or MP-8000
manual for ID set.
3) In case NLM-8000C was connected with the de-
vice normally, in case it is not communicated,
LINK ERROR is displayed. In this case, check
communication status (cable, etc.) again.
4) When there is no input for 10 seconds on the wait-
ing display, it is converted into sleep mode.
2. Device Set
It is a menu that can set the device.
Setting
1. ID
2. Termination
3. Firmware
4. Led Control
1) When the selection switch is pressed for 10 sec-
onds or longer on volume mode screen or channel
mode screen, it moves to the setting screen.
2) The menu pops up that can set if the switch is
turned. After turning the selected switch and mov-
ing to the menu desired, selection switch is
pressed and the menu is selected.
3) 6. When Back is selected, it returns to Volume
Mode.
LINK ERROR!
5. Factory Reset
6. Back
- ID Set
ID
1
ID Set
Select
Cancel
1) Device ID can be set.
2) In case ID is changed, if the selection switch is
pressed for 5 seconds or longer and the display
window ID phrase is changed into ID SET phrase
and ID can be changed.
3) When selection switch is pressed at the state ID value
to change is displayed after turning the selection
switch, Select, Cancel phrases are displayed. If Select
is selected, ID is changed and is cancelled if Cancel
is selected.
- Termination
Termination
OFF
1) You can check the device termination status.
2) This menu can check ON/OFF status of termination
resistance switch only, and the change can be
done only with the termination switch at the back
of the device.
3) If you press the selection switch, it returns to Set-
ting screen.
- Firmware
Firmware
Ver0.0.0.0
1) You can check the firmware version of the device.
- LeD Control
Led Control
ON
OFF
ID Set
1
Advertisement
