Table of Contents
Advertisement
Bromine Clear Water Plan
This plan and its chemical dosages are intended for Cal
Spas chemicals only. Most chemical manufacturers use
different chemical formulas and strengths. Only Cal spas
chemicals are specially formulated to provide chemical
balance at lower dosages. Always read and follow printed
instructions on chemical bottles and packages.
Day One (Monday)
1.
Test spa water using "Bromine Test Strips".
2.
Based on the Test Strip readings:
Adjust total alkalinity first (acceptable range of
•
80-120 ppm)
Then adjust the pH if needed. (range is between
•
7.2 to 7.8)
Add "Bromine Tablet(s)" if needed. (Do not add
•
more than 2)
The recommended level of bromine is 3-5 ppm.
•
3.
Add 2 oz of "Stain and Scale Defense".
Remove dirty filter from the spa and rinse off. Allow
4.
to dry.
5.
Place your extra clean filter cartridge back into the
spa.
6.
Vacuum debris from the bottom of your spa with the
"Spa Vacuum".
Day Two (Wednesday)
1.
Test spa water using Bromine Test Strips.
2.
Based on the Test Strip reading: Adjust total alkalinity,
then the pH if needed.
Day Three (Friday)
1.
Test spa water using Bromine Test Strips.
2.
Based on the Test Strip reading:
•
Adjust total alkalinity, then the pH if needed.
Add one Bromine Tablet (if needed).
•
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
3.
minutes with cover off.
4.
Replace cover.
2008 Inground Spa Owner's Manual
LTR20081002, Rev. A
Water Quality Maintenance
Chlorine Clear Water Plan
This plan and its chemical dosages are intended for Cal
Spas chemicals only. Most chemical manufacturers use
different chemical formulas and strengths. Only Cal spas
chemicals are specially formulated to provide chemical
balance at lower dosages. Always read and follow printed
instructions on chemical bottles and packages.
Day One (Monday)
1.
Test spa water using "Chlorine Test Strips".
2.
Based on the Test Strip readings:
First adjust total alkalinity (acceptable range of
•
80-120 ppm)
Then adjust the pH if needed. (range is between
•
7.2 to 7.8)
•
Add 2 tablespoons of Chlorine Granules.
The recommended level of Chlorine is 3-5
•
ppm.
3.
Add 2 oz of "Stain and Scale Defense".
Remove dirty filter from the spa and rinse off.
4.
5.
Place your extra clean filter cartridge back into the
spa.
6.
Vacuum debris from the bottom of your spa with the
"Spa Vacuum".
Day Two (Wednesday)
1.
Test spa water using Chlorine Test Strips.
2.
Based on the Test Strip reading: Adjust total alkalinity,
then the pH if needed.
Day Three (Friday)
1.
Test spa water using Chlorine Test Strips.
2.
Based on the Test Strip reading:
•
Adjust total alkalinity, then the pH if needed.
Add 2 tablespoons of Chlorine Granules. (if
•
needed)
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
3.
minutes with cover off.
4.
Replace cover.
Page 33
Advertisement
Table of Contents
