Removing Input Shaft; Remove Axle From Case; Remove Snap Ring From Axle Housing; Input Shaft Assembly - Columbia ParCar P4G Service Manual

Figure 26 - Removing Input Shaft
8. Remove the axles from the gear case halves.
See Figure 27.
Figure 27 - Remove Axle from Case
9. To remove axle from axle housing, remove retaining
rings at outer end of axle housing. Pull outward to
remove axle. Do not re-use retaining rings. See
Figure 28.
Figure 28 - Remove Snap Ring from Axle Housing
10. To disassemble input shaft, remove governor sleeve
and bearing. A puller will be required to remove bear-
ing. Use a new bearing when reassembling. See
Figure 29.
Figure 29 - Input Shaft Assembly
11. Remove the three screws holding governor plate and
weights to collar on the input shaft assembly. Use cau-
tion not to damage screws which are assembled with
locktite. See Figure 30.
Tightening Torque:
12 to 15 inch-lb.
(14-18Kgf. cm)
(1.37-1.76 N.m)
Figure 30 - Input Shaft Assembly when Disassembled
12. To disassemble center shaft assembly, press off bear-
ings (6204 & 6304), slide two gears, clutch collar and
spacers from shaft. Note the removal order for
reassembly of these components, or refer to illustra-
tions in your parts manual. Always, use new bearings
when reassembling. See Figures 31 and 32.
Figure 31 - Center Shaft Assembly
6-8