Spark Plug Wire Routing; Wire Routing, Typical; Installing Spark Plug Elbow; Installing Armature - Columbia ParCar P4G Service Manual

2. Tighten both screws to 45 in. lbs.(52 kgcm/kpcm).
See Figure 69.

Spark Plug Wire Routing

1. Route spark plug wire through notch in heat shield
and notch in blower housing, Figure 70.
Heat
Shield
Notch
Plug Wire
And Cable
Shield
Figure 70 - Wire Routing, Typical
Install Spark Plug Elbow
1. Insert spark plug wire through rubber boot into elbow
until wire stops, Figure 71.
2. Install threaded terminal with a screwdriver or until
terminal pierces wire and bottoms, Figure 71.
3. Install rubber cap on elbow, and slide rubber boot onto
elbow, Figure 71.
Spark Plug
Elbow Assembly
Figure 71 - Installing Spark Plug Elbow
Blower
Housing
Notch
Breather
Hose
Rubber Cap
Threaded Terminal
Rubber Boot
Spark Plug Wire
Install MAGNETRON
1. Install stop switch wire on armature. See Figure 72.
Sensor
Wires
Oil
Sensor
Figure 72 - Oil Sensor Wiring
2. Turn flywheel so magnet is away from armature.
Install armature on engine.
3. Install armature and mounting screws. See Figure 73.
Armature Pilot
Goes Here
Figure 73 - Installing Armature
Note: Mounting holes in armature are slotted.
4. Push armature away from flywheel as far as possible
and tighten one screw to hold armature in place.
Adjust Armature Air Gap - 13 H.P. Engine
1. Rotate flywheel until magnet is under armature
laminations.
2. Place thickness gauge, magnet and armature
laminations, Figure 74.
3. Correct air gap is minimum .008 inches (.020 mm.),
maximum .012 inches (0.31 mm.).
4. Torque both mounting screws to 25 in. lbs. (29
kgcm/kpcm2.8 Nm). Rotate flywheel to remove thick-
ness gauge.
7-30
®
Armature13 H.P Engine
Stop Wire
Wire Clip
Connector