Remove Magneto Ball Bearing - 13 H.p. Engines; Installing Bearing - Pto Side; Removing Bearing - Mag. Side - Columbia ParCar P4G Service Manual

Tool #
95951-96
Figure 136 - Installing Bearing - PTO Side
6. Install new oil seal. Use large end of Tool #95940-96,
Driver, and press in oil seal until flush with crankcase
cover.

Remove Magneto Ball Bearing - 13 H.P. Engines

Bearing Installation Tools
Tool/Part
Description
Washer
Puller Screw
Pilot
Support
1. Remove oil seal.
2. Assemble Part #95910-96, Washer, to Tool #95930-
96, Puller Screw and insert through large end of Tool
#95940-96 Driver.
3. Place open side of Tool #95951-96, Support against
ball bearing.
Tool #
95951-96
Figure 137 - Removing Bearing - Mag. Side
Tool #
95950-96
Tool #
95930-96
Part #
95910-96
Tool/Part #
9510-96
95930-96
95950-96
95951-96
95950-96
Tool #
Tool #
95930-96
95910-96
4. Insert screw with driver through ball bearing and
thread into support. Continue tightening screw until
ball bearing is removed, Figure 137.
Bearing Installation Tool Components
Tool/Part
Description
Washer
Puller Screw
Pilot
Support
Install Magneto Ball Bearing - 13 H.P. Engines
1. Lubricate outside diameter of ball bearing before
installing.
2. Place ball bearing on to Tool #95951-96, Support.
3. Assemble Part #95910-96, Washer to Tool #95930-
96, Puller Screw.
4. Insert small end of Tool #95950-96, Pilot into oil seal
boss in cylinder.
Tool #
Tool #
95930-96
95951-96
Figure 138 - Installing Bearing - Mag. Side
5. Insert screw through pilot and thread into support.
Tighten screw until ball bearing is seated, Figure 138.
7-54
Tool/Part #
95910-96
95930-96
95950-96
95951-96
95950-96
Tool #
Tool #
95930-96
95910-96