Intermediate Bearings Removal; Input Shaft Removal; Intermediate Shaft “O” Ring Removal; ‘O’ Rings Removal - Columbia ParCar P4G Service Manual

Figure 107 - Intermediate Bearings Removal
16. Repeat step 3-3 for intermediate bearing on opposite
side.
Caution: Shaft and gear assembly must be sup-
ported by hand as not to damage gear teeth.
Note: Small end of intermediate shaft and gear assem-
bly must be tilted toward opening in bottom of housing
for removal. Use caution as not to damage gear teeth.
17. Remove snap ring from input shaft bore.
Figure 108 - Snap Ring Removal
18. Pull input shaft assembly from housing. The input
shaft assembly should slide out of the housing easily.
If resistance is encountered, a slide hammer may be
required. Use caution as not to damage gear.
Figure 109 - Input Shaft Removal
19. Remove "O" rings from outer input bearing bore, and
both intermediate bearing bores.
Figure 110 - 'O' Rings Removal
20. Remove "O" rings at each end of intermediate shaft
on bearing shoulders.
Figure 111 - Intermediate Shaft "O" Ring Removal
21. Refer to page 1 for cleaning and inspection of com-
ponents.
22. Install new "O" rings into outer pinion bearing bore,
intermediate bearing bores and intermediate shaft
and gear assembly. Prior to installing, wipe "O" rings
with light oil or "O" ring lubricant.
23. Press inner and outer bearings on input shaft until
seated against bearing shoulders.
6-29