Connection To A Non-Smartcraft Network; Automatic Engine Detection Feature - Mercury MercMonitor Manual

Mercury Engine Data to J1939 Capable Products
Signal
RPM
Voltage
Coolant Temperature
Fuel Level
Fuel Consumption
Fuel Flow
Oil Pressure
Boost Pressure
Engine hours
Manufacturer ID
Alarm data
(Diagnostic message
supported)
Line‑Line AC RMS Volt Generator Set Average
AC RMS Frequency
Connection to a Non‑SmartCraft Network
The use of the MercMonitor on a non‑SmartCraft network application requires
the MercMonitor gateway set to "Receive." Failure to set the gateway to
"Receive" will cause numerous faults to appear that cannot be resolved.
Changing the gateway to "Receive" will clear the faults. The menu path to set
the gateway to "Receive" is: "Main Menu," > "Settings," > "Gateway," >
"Gateway."

Automatic Engine Detection Feature

The SmartCraft monitor has an automatic engine detection feature. This feature
automatically detects which engine type is used and configures the gauge to
match that engine type.
GENERAL INFORMATION
PGN Name
Electronic Engine
Controller #1
Vehicle Electrical Power
Engine Temperature #1
Dash Display
Fuel Economy (Liquid)
Fuel Economy (Liquid)
Engine Fluid Level/Press
#1
Inlet/Exhaust Conditions
Total Engine Hours
Address Claim (0 x 90 =
Mercury)
Check Engine
Generator Set Average
10
J1939 PGN
61444/0xF004 TX
65271/0xFEF7 TX
65262/0xFEEE TX
65276/0xFEFC TX
65266/0xFEF2 TX
65266/0xFEF2 TX
65263/0xFEEF TX
65270/0xFEF6 TX
65253/0xFEE5 TX
61182/0xEEFE TX
65226/0xFECA TX
65030/0xFE06 RX/TX
65030/0xFE06 RX/TX
Mode
eng