Adjustment Of Stretch Stitch Feed Balance - Janome HD 3000 Servicing Manual

ADJUSTMENT OF STRETCH STITCH FEED BALANCE

When a stretch stitch pattern is sewed with the 55 adjusting knob at a mark " " the pattern
should be formed as shown in the figure below. If not (if there is no balance between forward
feeding and backward feeding), then make adjustment in the following procedure.
(1) Remove the top cover (unit), and set the SS adjusting knob at a mark " "
(2) Put a piece of paper under the presser foot, and turn the balance wheel to check the needle
drop position in forward feeding (A) and backward feeding (B).
(3) If A > B, then turn the adjusting screw in direction of C.
If A < B, then turn the adjusting screw in direction of D.
(4) Attach the top cover (unit).
(Note)
After the above adjustment, readjust the zero feeding.
For removal and attachment of the top cover (unit), refer to page 2.
1 7