Adjustment Of Stretch Stitch Feed Balance - Janome MC6600 Service Manual

ADJUSTMENT OF STRETCH STITCH FEED BALANCE

WHEN THE NUMBER 8 IS SHOWN 5 TIMES WITH THE STRETCH STITCH BALANCE DIAL
(C) AT THE SETTING MARK (D), THE MEASUREMENT SHOULD BE BETWEEN 32 AND 38
MM AS SHOWN IN FIG. 1.
STRETCH STITCH
BALANCE DIAL (C)
BASE LID (E)
ADJUSTING SCREW (F)
(A)
(B)
32 - 38
FIG. I
SETTING MARK (D)
(B)
(A)
37
FIG. II
[TO ADJUST]
1. WHILE PRESSING THE NEEDLE UP/DOWN BUT-
TON AND LOCK STITCH BUTTON, TURN THE
POWER SWITCH ON. THEN PRESS THE NUM-
BER ì8î BUTTON WITHIN 3 SECONDS AS SHOWN
IN THE FIG II.
2. SET THE STRETCH STITCH BALANCE DIAL (C)
AT THE SETTING MARK (D).
3. SEW 8 OF NUMBER 8 AND CHECK IF THE MEA-
SUREMENT OF FIVE OF THEM IS BETWEEN 32
AND 38 MM.
4. IF NOT, REMOVE THE BASE LID (E), AND TURN
THE ADJUSTING SCREW IN THE DIRECTION OF:
(A) IF THE MEASUREMENT IS MORE THAN 38 MM.
(B) IF THE MEASUREMENT IS LESS THAN 32 MM.
* WHEN THE BUTTON IS PRESSED, THE AD-
JUSTING SCREW (F) COMES TO THE ADJUST-
ING POSITION. TURN THE ADJUSTING SCREW,
THEN PRESS BUTTON AND SEW
8 OF NUMBER 8.
5. TURN OFF THE POWER SWITCH.
6. ATTACH THE BASE LID (E).
38 MM
(GAUGE 846-G01)
32 MM