Stretch Stitch Feed Balance - Janome J30 Service Manual And Parts List

STRETCH STITCH FEED BALANCE

To check:
1. Enter the self-diagnostic mode (see below).
Attach the Satin stitch foot F. Place a fabric under the presser foot. Lower the presser foot.
2. Press the locking stitch button to start test sew, and check the results (the standard figure length of 5
pieces of figure 8 is 33-39 mm).
3. If stretch patterns are distorted, correct them with the feed balancing dial.
If stretch patterns are too deformed and cannot be corrected with the feed balancing dial, adjust as follows.
To adjust:
1. Remove the feed balancing dial cover. Turn the dial at standard position as illustrated.
Turn the power switch ON.
Select the straight stitch and set the stitch length at "0". Place a fabric under the presser foot.
Lower the presser foot. (Do not set bobbin and needle threads)
2. Turn the hexagonal socket screw to the left to loosen it.
Move the gear up (A) or down (B) to adjust the feed.
* Do not move the gear right or left when adjusting.
Start the machine and check the movement of the fabric.
Adjust the hexagonal socket screw position (gear position) until the fabric will not be fed with the stitch
length setting at "0".
3. Tighten the socket screw and attach the feed balancing dial cover.
Enter the self-diagnostic mode and test sew again. Check that the standard length of 5 pieces of figure 8 is
33-39 mm. If not, turn the feed balancing dial to correct it.
TO ENTER SELF-DIAGNOSTIC MODE:
Turn the power switch on while
simultaneously pressing auto-
lock button and needle up/down
button.
Incorrect Correct
36–39mm
The standard figure length of 5 pieces of figure
8 is 33-39 mm
MECHANICAL ADJUSTMENT
The LCD display will
indicate "01".
Incorrect
Press the value set key
7 times to display the "08".
(A)
(B)
15
Press the start/stop
button to display the
"88" and to enter
the stretch stitch test
mode.
Feed balancing dial cover
Feed balancing dial
(Standard position)
Hexagonal socket screw
Gear