Stretch Stitch Feed Balance Adjustment - Janome DC5100 Service Manual

SEWING MACHINE

STRETCH STITCH FEED BALANCE ADJUSTMENT

1. WHEN A STRECH PATTERN IS SEWN WITH THE FEED BALANCING DIAL (C) SET AT THE
STANDARD SETTING MARK ''
MARK IN THE FOLLOWING FIGURE. IF NOT (IF THERE IS UNEVENESS BETWEEN FORWARD
FEEDING AND BACKWARD FEEDING), THEN MAKE AN ADJUSTMENT AS FOLLOWS.
ADJUSTMENT PROCEDURE:
1. TURN THE POWER SWITCH ON, AND SELECT PATTERN NO.3 (
2. SET THE SLIT OF THE FEED BALANCING DIAL (C) AT THE STANDARD SETTING MARK ''
ON THE FRONT COVER.
3. PUT THE PAPER BETWEEN THE FOOT AND FEED DOG AND LOWER THE PRESSER BAR
LIFTER.
4. TURN THE HANDWHEEL, AND CHECK THE NEEDLE MARKS '' A '' AND '' B ''.
5. REMOVE BASE CUP ( D ).
6. IF THE LENGTH OF A IS BIGGER THAN THE LENGTH OF B, TURN THE ADJUSTING SCREW ( E ) IN
THE DIRECTION OF '' F ''.
IF THE LENGTH OF A IS SMALLER THAN THE LENGTH OF B, TURN THE ADJUSTING SCREW ( E ) IN
THE DIRECTION OF '' G ''.
7. ATTACH THE BASE CUP ( D ).
STANDARD
SETTING MARK
INDICATION LINE
1
A
A
A
2 B
3
A
A = B
MECHANICAL ADJUSTMENT (9)
'' , THE PATTERN SHOULD BE AS INDICATED WITH THE ''
FEED BALANCING DIAL ( C )
A
1
1
3
A
2
2
3
B
A > B A < B
).
B
26
MODEL DC5100
''
BASE CUP (D)
ADJUSTING
G
F
SCREW ( E )
''