Adjusting The Height Of The Display - Sony IPELA PCS-TL33 Operating Instructions Manual

Adjusting the Height of
the Display
The stand and the display section of the PCS-TL33 are
joined by fastening screws. There are three sets of screw
holes, spaced 25 mm apart. In the factory default
condition, the display is fixed in the lowest position. By
choosing a different set of screw holes, you can change the
height of the display.
1
Remove the rear cover of the unit.
For information on how to do this, see page 15.
2
Remove the 4 screws using a coin or similar object, lift
up the stand, and insert the positioning pin in the hole
for the new stand position.
Note
Before changing the height of the display as described
above, be sure to turn the power off. Place the display
face down on a soft cloth or similar.
16

Adjusting the Height of the Display

Positioning pin
3
Tighten the 4 screws using a coin or a similar object to
secure the stand.
4
Attach the rear cover again.