Sony IPELA PCS-TL33 Operating Instructions Manual page 109

Message
PPPoE server authentication has failed.
The standard encryption videoconference
with SIP connection is not available.
Connection using SIP is not available. 4xx
response received.
Connection using SIP is not available. 5xx
response received.
Connection using SIP is not available. 6xx
response received.
Connection using SIP is not available.
Rejection received.
Connection using SIP is not available.
Cancelled by the remote site.
Connection using SIP is not available.
Disconnected by the remote site.
Connection using SIP is not available.
Encrypted conference via LAN not
available.
Connection using SIP is not available.
Maximum presences over.
Connection using SIP is not available.
Provisional response timeout.
Connection using SIP is not available.
System call error.
Connection using SIP is not available.
Initialization error.
Connection using SIP is not available.
Unauthorized status.
Connection using SIP is not available.
Server internal error.
Connection using SIP is not available.
Network error.
Connection using SIP is not available. Line
is busy.
Connection using SIP is not available.
Parameter error.
Connection using SIP is not available.
Unauthorized handle.
Connection using SIP is not available.
Undefined error.
Connection using SIP is not available.
Memory over.
Connection using SIP is not available.
Request timeout.
The remote party rejects answering.
The conference could not start because the
signal encryption method at the near-end
side differed from that of the far-end side.
The encryption feature on a far-end system
is disabled.
The conference could not start because the
encryption feature at the far-end side was
disabled.
The encryption feature on a far-end system
is enabled.
The far-end system is not compatible with
the encryption feature.
Meaning
Enter the correct password.
When using an SIP connection, H.235 encryption is not available for encrypted
videoconferences.
Connection could not be established for example because the remote party uses
media not supported by the PCS-TL33.
Connection could not be established for example because of a SIP server error.
Check the SIP server.
Connection could not be established for example because the remote party could
not be found. Check the number etc. of the remote party.
Connection could not be established because the remote party rejected the
connection.
Connection could not be established because the remote party cancelled the
procedure.
Connection could not be established because the remote party cancelled the
procedure.
When LAN encryption is enabled, a SIP connection cannot be established.
Connection could not be established because the number of presences was
exceeded.
Connection could not be established because after sending there was no
response from the remote party within the prescribed period.
Connection could not be established because of a system problem.
Connection could not be established because of an initialization problem.
Connection could not be established because of an undefined error.
Connection could not be established because of an internal error.
Connection could not be established because there is a network problem. Check
the condition of the network.
Connection could not be established because the line of the remote party is busy.
Connection could not be established because of wrong settings. Check the
settings on the SIP Setup menu etc.
Connection could not be established because of an internal error.
Connection could not be established because of an undefined error.
Connection could not be established because of insufficient memory in the
PCS-TL33.
Connection could not be established because there was no response from the
remote party within the prescribed period.
Check the settings of the remote party.
Connection cannot be established if the local and remote parties use different
encryption methods.
When attempting to start a videoconference using LAN encryption, it is not
possible to connect if LAN encryption on the remote system is not turned on.
Connection cannot be established if the encryption function on the remote site is
off while the encryption function on the local site is on.
When attempting to start a normal videoconference without encryption, it is not
possible to connect if LAN encryption on the remote system is turned on.
When attempting to start a videoconference using LAN encryption, it is not
possible to connect if the remote system does not support LAN encryption.
109
On Screen Messages