Sony IPELA PCS-TL33 Operating Instructions Manual page 110

Message
The remote terminal may not be registered
in gatekeeper. Contact the gatekeeper
administrator.
Call not responded.
The entered password for the encryption
feature is not correct.
At least thirteen characters are required as
a password for the encryption feature.
Temperature is abnormal. The power will
turn off.
Check the line interface or the IP address is
set correctly.
No camera device is detected.
GateKeeper error.
Gatekeeper does not respond.
Gatekeeper does not respond.
Connection has been rejected as the data
exceeds the bandwidth of a gatekeeper.
Gatekeeper registration error. Check LAN
configuration.
The conference could not start because the
encryption feature at the near-end side was
disabled.
RGB input signal not acceptable.
Communication ends.
Communication starts!
No more entries can be registered.
The system will be reset.
The terminal with the specified IP address
does not exist, or the system is turned off.
Please wait.
Dialing your own number is invalid.
Now upgrading. Wait for a while. Be sure
not to turn off your system while upgrading.
Still image saved to Memory Stick.
The still image has been sent.
Incorrect still image format. Progressive
JPEG is not supported.
A still image is being sent or received. The
Data Solution Module (DSM) cannot be
used.
Still image transmission cancelled.
The still images were not sent.
The software upgrade is complete. The
system will now restart.
Input title.
Network congestion: Try again later.
The network is heavily congested at the
moment. Some pictures may appear
distorted.
Adjusting the white balance. Please wait.
The Data Solution Module (DSM) cannot be
used.
The power will turn off. Please wait.
110
On Screen Messages
Meaning
Contact the gatekeeper administrator regarding registration of the remote party
terminal.
Check connections of videoconferencing equipment at the remote party.
Enter the correct password.
The password required for conducting videoconference using LAN encryption
must be between 13 and 20 characters long.
The system is shutting down because abnormal temperature was detected.
Check whether the line type and IP address settings in the LAN Setup menu are
correct.
The camera could not be detected for some reason.
Check the remote party address.
Check the gatekeeper settings.
User name and user number were entered, but the call could not proceed. Contact
the gatekeeper administrator or enter the IP address of the remote party and retry
the call.
The connection requirements exceed the bandwidth limitations of the gatekeeper.
Contact the gatekeeper administrator for information about gatekeeper registration
for the remote party terminal.
Connection cannot be established if the encryption function on the remote site is
on while the encryption function on the local site is off.
The RGB input signal in use is not compatible.
Steps for ending a videoconference were completed successfully.
Connection was established successfully and the videoconference can be started.
The maximum number of entries for the Phone Book has been reached.
The system is restarting.
Connection to the remote party could not be established. Check whether the
specified IP address is correct, or have the remote party turn the power on.
Data are being saved.
Check the address for the remote party.
The software version of a camera device, LCD, or other equipment is being
upgraded. Do not turn power off until the upgrade process is completed.
The still image was saved on the "Memory Stick".
Still image data were sent.
A JPEG file on the "Memory Stick" could not be decoded. The Progressive JPEG
format is not supported.
Wait until still image transmission is completed before using the Data Solution
Module (DSM).
The still image transmission was cancelled.
The still image sending attempt failed.
The software upgrading process has completed normally.
Enter an index title.
Available bandwidth is limited due to network congestion.
Data losses are occurring due to heavy network traffic. Video/audio quality may be
impaired.
The white balance is being adjusted. When cancelled, the message will disappear,
but the camera adjustment process is not cancelled.
The Data Solution Module cannot be used.
The system is shutting down.