Miele EVS 7010 Operating And Installation Instructions page 49

Aligning the front of the drawer
After installing the combination appli-
ance, it may be necessary under certain
circumstances to align the front of the
drawer and adjust the gap between the
drawer and the combination appliance.
To help you do this, there are 2 screws
behind the drawer front with which the
front is fixed to the drawer housing.
 Open the drawer.
 Loosen the fixing screws  on the
right and left of the drawer housing.
Do not remove the screws com-
pletely, as the front may fall off.
 Push the drawer up or down a little to
correct the alignment and the gap.
 Tighten up the fixing screws.
Installation
49