Installation
Installing and connecting the drawer
Check that the air filter is fitted and
the safety screws have been removed
from the back of the drawer (see "In-
stallation – Preparing the drawer").
Connect the power cable to the
drawer.
Slide the closed drawer into the
housing unit. When doing so make
sure that the power cable does not
get trapped or damaged.
Align the drawer at right angles.
Open the drawer and secure it to the
right and left-hand side walls of the
housing unit with the 2 wood screws
supplied (3.5 x 25 mm).
Remove the 4 foam adhesive labels
from the back of the front panel on
the right and left-hand sides.
Connect the drawer to the power
supply.
48
When the drawer is first connected, or
after an interruption to the power sup-
ply, all of the sensor controls and in-
dicators in the display will light up for
approx. 10 seconds for testing (initial-
isation). As soon as they go out, the
drawer is ready for use.
Install the combination appliance in
accordance with the operating and
installation instructions supplied with
it.