Retract Air System Installation - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Instruction Manual

11. Mount the ignition module to the fi rewall. Use the instructions
provided with the engine to connect the module to the engine and
ignition battery.
EN

RETRACT AIR SYSTEM INSTALLATION

1. Cut a 12-inch (305mm) piece of air line and attach it to the air tank.
 Use a heat gun on low to soften the air lines
slightly so they will slide on the fittings.
2. Remove the servo arm from the rudder servo. Place straps around
the tank in the fuselage.
3. Apply a small amount of contact adhesive on the tray. Use the straps
to secure the air tank in the fuselage.
4. Route the air line under the servo tray to the location for the air
valve.
5. Cut two 4 inch (102mm) pieces of orange air line and one 4 inch
(102mm) piece of blue air line. Attach the orange air lines to the
fi tting near the end and center fi ttings of the air valve, and the blue
air line to the fi tting near the actuator.
 Do not remove the actuator from the valve body as it will
damage the O-rings and cause an air leak in the valve.
 Use a heat gun on low to soften the air lines
slightly so they will slide on the fittings.
30