Yamaha YZF-R3 2020 Owner's Manual page 25

3. Turn the main switch on and re-
lease the "SELECT" button after
five seconds. The shift indicator
light can now be adjusted.
To set the flashing pattern
1. Push the "RESET" button to select
one of the following flashing pat-
tern settings:
On: the indicator light stays
on when activated. (This set-
ting is selected when the indi-
cator light stays on.)
Flash: the
flashes when activated. (This
setting is selected when the
indicator light flashes four
times per second.)
Off: the indicator light is deac-
tivated; in other words, it
does not come on or flash.
(This setting is selected when
the indicator light flashes
once every two seconds.)
2. Push the "SELECT" button to con-
firm the selected flashing pattern.
The shift indicator light changes to
the activation point setting mode.
The tachometer will show the current
setting r/min for the activation point
and deactivation point setting modes.
To set the shift activation point
TIP
The shift indicator light activation point
can be set between 7000 r/min and
13500 r/min. From 7000 r/min to 12000
r/min, the indicator light can be set in
Instrument and control functions
indicator light
4-9
increments of 500 r/min. From 12000
r/min to 13500 r/min, the indicator light
can be set in increments of 200 r/min.
1. Push the "RESET" button to select
the desired engine speed for acti-
vating the indicator light.
2. Push the "SELECT" button to con-
firm the selected engine speed.
The control mode changes to the
deactivation point setting mode.
To set the deactivation point
TIP
The shift indicator light deactiva-
tion point can be set between
7000 r/min and 13500 r/min. From
7000 r/min to 12000 r/min, the in-
dicator light can be set in incre-
ments of 500 r/min. From 12000
r/min to 13500 r/min, the indicator
light can be set in increments of
200 r/min.
Be sure to set the deactivation
point to a higher engine speed
than for the activation point, other-
wise the shift indicator light will not
come on.
1. Push the "RESET" button to select
the desired engine speed for de-
activating the indicator light.
2. Push the "SELECT" button to con-
firm the selected engine speed.
The control mode changes to the
brightness setting mode.
To adjust the brightness
1. Push the "RESET" button to select
the desired shift indicator light
brightness level.
4