Yamaha YZF-R3 2020 Owner's Manual page 21

Tachometer
1. Tachometer
2. Tachometer red zone
The tachometer shows the engine
speed.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 12500 r/min and above
Clock
1
1. Clock
The clock uses a 12-hour time system.
To set the clock
1. Turn the main switch on.
2. Push both the "SELECT" and "RE-
SET" buttons for two seconds.
The hour digits will flash.
3. Push the "RESET" button to set
the hours.
Instrument and control functions
1 2
MPH
MPG mile
ECA10032
MPH
MPG mile
4. Push the "SELECT" button. The
minute digits will flash.
5. Push the "RESET" button to set
the minutes.
6. Push the "SELECT" button to start
the clock.
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
ments of the fuel meter disappear from
"F" (full) towards "E" (empty) as the fuel
level decreases. When the last seg-
ment starts flashing, refuel as soon as
possible.
TIP
If a problem is detected in the electrical
circuit, the fuel level segments will flash
eight times then go off for three sec-
onds repeatedly. If this occurs, have a
Yamaha dealer check the electrical cir-
cuit.
4-5
MPH
4
MPG mile
1