Fuji Xerox DocuPrint P375 d User Manual page 216

Error Message
No Tray T1
No Tray T2
No Tray T3
Out of Memory
Print Data Full
Print Unable ##
Replace Drum
Replace Toner
Self-Diagnostic
Size Error
Size Error DX
Size Mismatch
Toner Low
Too Many Trays
Related Information
• Troubleshooting
Cause
The paper tray is not installed or
not installed correctly.
The machine's memory is full.
The machine's memory is full.
The machine has a mechanical
problem.
It is time to replace the drum
cartridge.
The drum cartridge counter was
not reset when a new drum
cartridge was installed.
The toner cartridge is at the end of
its life. The machine stops all print
operations.
The temperature of the fusing unit
does not rise to a specified
temperature within the specified
time.
The fusing unit is too hot.
The paper size defined in the
printer driver is not supported by
the defined tray.
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
The paper in the tray is not the
correct size.
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
The number of installed Tray
Modules (Optional) exceeds the
maximum number.
Action
Reinstall the paper tray indicated on the LCD.
Press Cancel and reduce the print resolution.
Press Cancel and delete the previously stored
secure print data.
• Press and hold to turn the machine off,
wait a few minutes, and then turn it on
again.
• If the problem continues, contact Fuji Xerox
customer service.
Replace the drum cartridge with a new one.
See Related Information: Replace the Drum
Cartridge.
Reset the drum cartridge counter.
See the instructions included with the new
drum cartridge.
Replace the toner cartridge with a new one.
Press and hold to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
Choose a paper size supported by the defined
tray.
Press Cancel (if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
(For models without the lever on the 2-sided
tray) Paper size available for automatic 2-
sided printing is A4.
(For models with the lever on the 2-sided tray)
Paper sizes available for automatic 2-sided
printing are A4, Letter, Legal, Mexico Legal,
India Legal and Folio.
Load the correct size of paper in the tray
indicated on the LCD and set the size of paper
for the tray. Press Go.
Order a new toner cartridge now so you have
it ready when the LCD displays Replace
Toner.
Reduce the number of Tray Modules
(Optional).
212