Triumph TR2 Service Instructions Manual page 296

BODY
SEALING
RUBBER
SECTION T H R ~ ATTACHMENT POINT.
NOTE
:-
'
7T.H
CLIP IN PILLAR
YDIA.
HOLES
SEALING
RUBBER
Front Door Water Sealing. For illustration purposes, only the right-hand door is shown.
(c)
When fitting the side screen retainer
brackets the correct position is only
obtained by fitting them so that the
heads of the locking screws face
inwards. Having replaced the
brackets it is a wise precaution to
check the fitting of the side curtain.
26.
REMOVAL OF GEARBOX
TUNNEL
(a) Lift out seat cushions and remove eight
nuts from each seat. Lift out seats.
(b) Remove front carpets and underfelts.
(c)
Release hand brake and speedo drive
draught excluder and slide this up the
brake lever.
(d) Withdraw the sixteen fixing bolts
around the flange of the tunnel.
On early R.H.S. production cars it is
necessary to remove the dipper switch
and bracket (3 bolts).
(e)
If the car is fitted with overdrive.
disconnect the electric control wires
at their snap connectors and feed
them through the aperture in the
tunnel.
(f) Withdraw the drain pipe from fron
portion of tunnel.
(g)
Remove screws from gear levr
grommet and push the rim of
tf
grommet through the aperture.