Triumph TR2 Service Instructions Manual page 140

GEARBOX
Fit countershaft front end cover plate
and paper joint securing with two set-
screws and washers using lead linger
and wiring as necessary.
Assemble gearbox extension and paper
joint, securing with six setscrews and
washers, using lead linger and wiring
as necessary.
Install thrust washer and ball race into
gearbox extension with suitable tool as
shown in Fig. 25.
Locate gearbox extension oil seal as
shown in Fig. 26.
Install speedometer driving gear and
accommodating bush, securing with
special setscrew.
Fig. 28
Fitting Front Cover Oil Seal with Tool No.
2oSM. 73.
(U) Fit front cover, having installed oil
seal as shown in Fig. 28, utilising
fitting tool to protect oil seal (see
Fig. 29).
Fig. 26
Fitting Extension Housing Oil Seal with
Churchill Tool No.
2 0 s .
87.
(S)
Fit plain washer, slotted nut as shown
in Fig. 27, tightening to 85-100 lbs.
ft., and instai: split pin.
Fig. 29
Assembling Front Cover, utilising Chur-
chill Tool No. 2oSM. 47 to protect Seal
Face.
Fig. 27 Tightening Driving Flange Securing Nut
with torque spanner and Churchill Tool
No. 2oSM. 90.
Fit four setscrews and plain washers
with lead linger after positioning the
slot in the face of the front cover
horizontally at 9 o'clock and wire
setscrew heads.