Triumph TR2 Service Instructions Manual page 148

GEARBOX
SUPPLEMENTARY INSTRUCTIONS FOR INCORPORATING
OVERDRIVE ON SECOND
"
AND "THIRD
"
GEARS
Fig.
40
Ghost view of Top Cover Assembly.
(iii) Withdrawing the pivot bolt (3)
(f) Remove 1st and 2nd speed selector
to enable the change speed lever
shaft retaining screw (6), spring and
assembly to be withdrawn.
4"
locking ball and slide this selector
shaft rearwards clear of the casting to
Caution. When withdrawing enable the removal of the selector
the change speed lever assembly,
fork.
ensure that the anti-rattle spring
and retainer, which is located on
(g)
Remove
"
Reverse
"
selector fork and
the spherical part of the lever,
shaft (9) carrying out the procedure
is retained for re-assembling.
as in (f) above, excepting that the
shaft is positioned by a plunger,
(d) Remove the three wire locked stop
spring, distance piece and retaining
screws (4).
screw instead of the ball, spring,
and retaining screw.
(ej
Unscrew and remove the three wire
(h)
Remove 3rd and
"
Top
"
speed select-
iocked screwed taper pins (5) securing
or shaft (7) and fork, carrying out
the forks to the selector shafts.
the procedure used
in (f) above.
25