Related Manuals for Whirlpool AGB 505/WP
Summary of Contents for Whirlpool AGB 505/WP
- Page 1 006_03 10/2005 Installation, operating and maintenance instructions ELECTRIC TILTING COOKER AGB 505/WP AGB 507/WP...
-
Page 2: Table Of Contents
INDEX Models and dimensions Possible failures and their elimination page page General reminders and notes Use and cleaning General reminders Warnings and hints for user Technical data Instructions for use Construction Switch on, start Laws, technical prescriptions of cooking and switch off and directives Special precautions Special requirements... -
Page 3: Models And Dimensions
Models and dimensions AGB 505/WP - AGB 507/WP Technical data plate Water connection D.12mm Electrical connection 006 - 03 - Electric tilting cooker... -
Page 4: General Reminders And Notes
Model Dim.: LxWxH Voltage rating Power Lead wire / Section (mm) AGB 505/WP 800 x 700 x 875 230 V 3 AC or 400 V 3N AC 8.0 kW 4 x 2.5 mm or 5 x 1.5 mm AGB 507/WP... -
Page 5: Construction
When installing the appliance it is necessary to follow and - Stainless steel pan with steel bottom in model comply with the following regulations: AGB 505/WP. - current regulations on the matter; - Stainless steel pan with bimetal bottom in model - any hygienic-sanitary regulations concerning cooking AGB 507/WP. -
Page 6: Electrical Connections And Equipotential Bonding
Electrical connections - In addition, check that once the appliance has been in- and equipotential bonding stalled, the power cord is neither subject to stretch nor in contact with nor surfaces. Warning!: The appliance is supplied to operate - Now proceed to light the appliance as directed in the in- according to the power supply indicated on the data structions for use. -
Page 7: Use And Cleaning
USE AND CLEANING WARNINGS AND HINTS SPECIAL PRECAUTIONS FOR USER The grills, particularly those with the pan bottom not in stain- - This manual contains all the instructions required for a less steel, are treated in the factory with mineral oil to protect proper and safe use of our appliances. -
Page 8: Special Procedures
SPECIAL PROCEDURES - Remove the insulation protection (Pos. B), unloosing the IN CASE OF PROLONGED INACTIVITY fixing screws to the pan. - Remove the protection panel of heating elements. (Pos. C). - If the appliance is to stand idle for any length of time (e.g. - Remove the heating element support plate (Pos. -
Page 9: Weee Directive
THE 2002/96/EC DIRECTIVE (WEEE): information to users This informational note is meant only for owners of equipment marked with the symbol shown in Fig. A on the adhesive label featuring the techni- cal specifications applied on the actual product (the label also giving the serial number). This symbol indicates that the product is classified, accor- ding to the regulations in force, as an item of electrical and electronic equipment and conforms to EU Directive... -
Page 10: Wiring Diagrams
Wiring diagrams CBRE CBREIN 12 14 16 11 13 15 400 V 3N~ 8 kW L1 L 2 L 3 N 12 14 16 L1 L 2 L 3 230 V 3~ Line input terminal board Switch Microswitch Safety contactor Adjusting contactor Adjusting thermostat Safety thermostat... -
Page 11: Replacement Of Heating Element
Replacement of heating element Fixed front panel Rear protection Heating element protection panel Suport plate for heating element Heating element Nut M8 Boss for bulb protection Bulb Control knob Control knob Off position Minimum position Maximum position 006 - 03 - Electric tilting cooker... -
Page 12: Warning
TO MAKE ANY CHANGES DEEMED NECESSARY. THE MANUFACTURER CANNOT BE HELD RESPONSI- BLE IF THE INSTRUCTIONS CONTAINED IN THIS MA- NUAL ARE NOT OBSERVED. WHIRLPOOL EUROPE srl V.le Guido Borghi, 27 I – 21025 Comerio – VA 006 - 03 - Electric tilting cooker...
Need help?
Do you have a question about the AGB 505/WP and is the answer not in the manual?
Questions and answers