Basic Functions; Activating And Deactivating; Selecting A Source - Teufel CoreStation Technical Description And Instruction Manual

Activating and deactivating

• You can switch the CoreStation on by briefly push-
ing the button (6) on the back of the device or
(32).
The function LED (19) will briefly light up in white
during start-up.
• You can switch the CoreStation to standby by
pushing and holding the button (6) or
approximately one second. The LED POWER (5) will
continuously light up in red during standby.
• If the TV that is connected via HDMI is CEC-capable,
the CoreStation will be switched on and to standby
together with the TV set (see "CEC" on page 21).
• If a CEC-capable HDMI device is connected to one
of the HDMI IN connections (2), the CoreStation
and the TV set will also be activated when the
HDMI device is turned on.
• If the CoreStation does not receive any signal for
more than 30 or 60 minutes, it will automatically
switch to standby (see "Auto-off" on page 21).
In standby the function LED (19) will illuminate in red.
The CoreStation is not disconnected from the mains
in standby mode. Pull the mains plug out of the mains
socket to completely deactivate it.

Selecting a source

Use the buttons (27) on the remote control to select
the most important source devices:
• TV TV set
• BT Bluetooth device (see page 23)
• FM Radio mode
You can use the special function buttons (28) to
select the other sources; the buttons are assigned as
follows by default:
But- Push 1 x
ton
AV HDMI 1
1 AUX 1
2 OPTICAL 1
3 COAX
4 HDMI 3
You can change the assignment of the buttons (28) in
the "Special Function Buttons" menu (see page 21).
(32) for
Push 2 x
HDMI 2
AUX 2
OPTICAL 2
AUX 3
HDMI 4

Basic functions

32
2
27
28
19
5 6
• CoreStation 17