Table of Contents
Advertisement
Setup / Mounting
Setup location
You can set up the CoreStation in a concealed loca-
tion as the remote control operates with radio signals.
When setting the device up in a cabinet, make sure
that it is adequately ventilated and aerated to prevent
the CoreStation from overheating.
Location tips
• Select a stable, level base whose carrying capacity
is sufficient for the CoreStation and TV set.
• Make sure that the environment is clean and free
from dust.
• Select a location away from heat sources and direct
sunlight.
• Lay the connector cables so that they do not pose a
tripping hazard.
• Do not place any heavy objects on the cables.
Mounting behind a TV set
You can also mount the CoreStation behind a suitable
flatscreen TV using the enclosed mounting brackets
• The TV set must be in a stable position and may not
be secured with a wall bracket.
• It must be prepared for a wall bracket in accord-
ance with VESA MIS-E or MIS-F. TV sets of this type
have a stable mounting frame under the rear panel.
Only the outside holes 200 mm (VESA MIS-E) or
400 mm apart (MIS-F) are visible from the outside.
Please refer to the instruction manual for your TV
set.
You will still need two or four screws that fit the VESA
holder on your TV set. For this, be absolutely sure to
observe the notes in the instruction manual of your
TV set. These screws may not be too long and are not
part of the product contents of the CoreStation.
1. Use the enclosed eight screws
two mounting brackets
CoreStation as shown in the figure.
10
• CoreStation
to the screw the
onto the bottom of the
:
Hide quick links:
Advertisement
Table of Contents
