P
OWER CABLING
If you use thick cables insert the cable insulators in between the terminals in
9
order to avoid contact between the cables.
Connect the cables stripped as shown in Figure 24.
•
Connect the (phase) conductors of the supply, brake and motor cables
into their respective terminals (a).
•
Form the rest of the cable shield of all cables into "pigtails" and make a
10
grounding connection as shown in Figure 34 (b) using the clamp from the
Accessories bag
•
NOTE: If you use several cables on one connector observe the position of
cable lugs on top of each other. See Figure 35 below.
Figure 33.
.
Honeywell
• 38
4