Table of Contents
Advertisement
Honeywell
• 29
Insert the cable grommets (included in the delivery) in the openings of the cable
4
entry plate (included) as shown in the picture (upper pictures EU version, lower
pictures US version).
•
Insert the cables - supply cable, motor cable and optional brake cable - in the
openings of the cable entry plate.
•
Then cut the rubber grommets open to slide the cables through. Should the
grommets fold in while inserting the cable, just draw the cable back a bit to
straighten the grommets up.
•
Do not cut the grommet openings wider than what is necessary for the cables
5
you are using.
IMPORTANT NOTE FOR IP54 INSTALLATION:
To meet the requirements of the enclosure class IP54, the connection between
the grommet and the cable must be tight. Therefore, lead the first bit of the cable
out of the grommet straight before letting it bend. If this is not possible, the tight-
ness of the connection must be ensured with insulation tape or a cable tie.
Figure 17.
P
OWER CABLING
Advertisement
Table of Contents
