First EMV100 800 Series Manual page 97

ELECTRICAL CABLES CONNECTION
1. Flush mounted connection
Cables in the wall case lead through the holes at the bottom
of thermostat.
2. On-wall connection
a)
a) Lead cables into the thermostat housing like as shown on the
picture. On one side lead the sensor cables and on the other the
rest. With two discharger screw the cables very tight to
prevent the extraction.
b)
b) If it's not enough space for cables, use the knife and widen
the lead.
c)
c) Cut the holes for cables lead on the housing cover
d)
d) Use the knife and cut on spots 1 and 2 and brake remain.
ELECTRICAL CONNECTION:
Before each interventions in the thermostat first dis-
connect the main power!
Non-isolated part of the conductor must be in the terminal
housing!
CHOOSING WORKING REGIME
Choosing working regime
Before first of use, the working regime must be selected. It is set
by jumpers in the electronic circuit. -
For each application is specific jumper position.
In further by every example is stated jumper's position.
Possible jumper's settings:
DTC 200
for example:
97
page