Bridging Of Sampled Values Streams - ABB SAM600 Operation Manual

1MRK 511 434-UEN B
Process Bus to PRP LAN-A
(optional with IEEE time
synchronization)
Process Bus to PRP LAN-B
9-2LE bridge through
IEC18000519 V1 EN-US
Figure 8:
Figure 8
SAM600 system bus is set-up as HSR ring. Note that the ring can span optical and electrical
links as it connects SAM600 modules in two different marshalling kiosks.
Access points on SAM600-TS modules can be configured as redundant communication links
according to the PRP or HSR standard. A combination of optical and electrical links can be used
as necessary. Note that each SAM600-TS module supports one redundant access point. Two
(three, in case of a SAM600 system bus daisy chain) additional single link access points can be
configured on the SAM600-TS module.
2.3.3

Bridging of sampled values streams

Access points in a SAM600 system can be configured for bridging incoming IEC/UCA
61850-9-2LE traffic into a SAM600 system to outgoing IEC 61850 access points in the SAM600
system, thus providing switching functionality for IEC/UCA 61850-9-2LE traffic.
SAM600 Process Bus I/O System
Operation Manual
Kiosk
X104
SAM600 TS
X101
Kiosk
SAM600 CT
X104
Process Bus
(single link, electrical)
SAM600 System configured for redundant communication
depicts a SAM600 system configured for increased communication reliability. The
A SAM600 system does not influence nor maniplulate the payload of a bridged
message.
Each SAM600 module can receive a maximum of 8 bridged streams on all its
uplink ports.
On a SAM600 module up to three IEC 61850 access points can be configured
for receiving bridged streams.
© Copyright 2017 ABB. All rights reserved
X103 X104
SAM600 TS
X101
X102
Redundant SAM600 System Bus
X101
X102
SAM600 VT
X103 X104 X101
SAM600 Process Bus I/O System
X106
Process Bus HSR
(optional with IEEE time
synchronization)
X107
9-2LE bridge through
Process Bus
(single link, optical)
GUID-E79AC8AF-DA58-4A48-9A26-E49F4B458BA5 v1
Section 2
15