Table of Contents
Advertisement
Section 10 R outine
M aintenance
1. We recommend that the electrical isolator
is switched off during maintenance to stop
the unit being switched on accidently.
2. The cover should only be cleaned using a
soft cloth and that the use of abrasive or
solvent cleaning fluid is to be avoided as
this can damage the plastic.
3. We recommend the spray arm to be
cleaned periodically to remove any lime
scale or debris which will reduce the
performance of the unit. In hard water
areas cleaning may be needed more often
than in soft water areas.
4. Scrub the spray plate at the end of the
spray arm with a small stiff bristled brush.
If the deposits are stubborn remove the
central spray rings with the central screw
and immerse in a lime scale remover
solution.
Section 11
Troubleshooting
1. Water is too hot
Increase the water flow by turning control dial
anti clockwise to increase the flow.
2. Water is too cold
Decrease the water flow by turning the control
dial clockwise to decrease the flow
3. Water takes too long to heat up
Thermal cut out has operated after the previous
use and will automatically reset.
4. Water goes cold while using
handwash
Check the water pressure has not fallen so far
that the pressure switch has switched off
5. Spray Pattern is poor
Remove spray plate from the spray arm and de
scale.
Section 12 After
Sales Service
Please call our technical team on:
0344 879 3588
Or alternatively email us on:
customer.services@glendimplex.com
Remember to quote the exact type of handwash,
as written on the front of the unit and on this
leaflet.
The model and serial number are located on the
bottom face of the handwash.
Make a note of those numbers here, and be sure
to quote them if you call for advice.
M odel Num ber:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Serial Num ber:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE: You m ay be charged for a service
call if you do not have the serial num ber.
6
Advertisement
Table of Contents
